B9 Electronics: The Inside Story Part 6 – the Finger Lights, Brain & Crown Animation

As I was using the light controller from Tom for the belly and chest lights, so to am I using another board from Tom for the finger and brain lights. It’s basically the same board as the chest and belly lights controller card used in the Torso. The reason I used another one was so that I could get a different blinking and pattern rate than the torso. I wanted an asynchronous blinking pattern between the 2 sections. To me this gives a more realistic appearance of a real, functioning robot. Just as a side note, you could hook up everything to 1 controller card but I wanted that certain, special, something that only 2 cards can provide.
The crown and finger light movement is handled by the Hankscraft 12v 7rpm motor. You can obtain this motor from a number of sources and is readily available. The average price for this motor is 25.00. What I had a problem with was the wires coming out of the brain and finger lights passing through the brain cup into the neck. As you can see from the picture on the left from the B9 website, there isn’t much room and I had to remove the wire sheaths and drill out additional wire routes to go around the Hankscraft motor. It is a VERY tight fit. Take care not to kink the thin wires coming out of the finger lights.

Leave a Reply

Your email address will not be published. Required fields are marked *